SambaPOS Forum

English Boards => Support => Topic started by: captain_farrell on March 23, 2013, 11:11:36 am

Title: Autocut
Post by: captain_farrell on March 23, 2013, 11:11:36 am

Hi everyone.
Is there any possibility to make each item separate cut on kitchen printer. Printer should cut after each item. I wanna use them, item by item.
Have a good day.
Thanks.

Title: Re: Autocut
Post by: JohnS on March 28, 2013, 08:06:20 pm

I haven't tried this yet, but here we go.

1..Find the printer code to cut the paper and test using <XCT> tag in the Line Item section
2..Move all the header and footer content of the kitchen printer template into the Line Item section and add the printer cut code last

The theory is that as it prints each item, you will have a ticket with the table info, time, etc, the item and then cut the ticket.

PS - if you can't find the code for the cutter, try using the form feed code instead.